Installation Guide

Installing your RideGlow takes about 30 seconds. No tools required.

Step 1: Clean the Surface

Wipe the underside of your car door with a dry cloth. Make sure the surface is clean and dry for the best adhesion.

Step 2: Peel the Adhesive

Remove the protective backing from the 3M adhesive pad on the back of your RideGlow unit.

Step 3: Position and Stick

Press the RideGlow firmly onto the underside of your car door, near the hinge side. The LED lens should point downward toward the ground. Hold for 10 seconds.

Step 4: Test It

Close your car door, then open it. The magnetic sensor will activate and your logo will project onto the ground. If the projection angle needs adjustment, gently reposition while the adhesive is still fresh.

Tips for Best Results

• Install in a clean, dry environment for the strongest adhesive bond.
• The projection is most visible at night or in low-light conditions.
• Optimal projection distance is 2-4 feet from the ground.
• The adhesive is removable and leaves no residue if you need to reposition.

Charging

When the projection starts to dim, charge your RideGlow using the included USB-C cable. A full charge takes about 2 hours and lasts 6+ months of typical use.